Marthy
Member
One last question, does the rear wheel have to be off the ground to calibrate te map and speed sensor?
The pre-program value from Dynojet are pretty spot on for the gears usually. But if you don't run the stock gearing yes, you need to have the rear wheel off the ground.
1st you need to set the scalar #
Lets assume that your speedo is calibrated. Set the speed at 40 MPH to calibrate the scalar #. With the wheel off the ground in 6th gear (less rpm) nbring up the speedo to 40MPH then click calibrate on the computer screen.
Then you need to do each gears. That's easier. Just go thru all gear 1-6 and hit calibrate to each of them. Then at the end you click "blend" or something like that on the bottom of the window... and your done. But I won't worry too much with that... Dynojet should have it all configure right.