So, question for you electrically inclined riders. I'm confused as to how to wire up 2-wire frong LED's to our 3-wire system.
The original incandescent bulbs have three wires: 1 for blinker filament, 1 for running filament, and a third wire for ground.
I used this guide to try and get running light functionality while still blinking:
Is it possible to make rear blinkers light up all the time...
It made sense, except that on our bikes, the running light voltage never drops out while you turn on the blinker. It's 12VDC constantly. The blinker wires alternate 12V while active.
Anyone know how to wire them up so the running light functionality works along with blinkers?
I dont want to waste 25 bucks on a 'blinker genie' when all they have in there are some diodes, just like the guide shows. I'm stumped.
The original incandescent bulbs have three wires: 1 for blinker filament, 1 for running filament, and a third wire for ground.
I used this guide to try and get running light functionality while still blinking:
Is it possible to make rear blinkers light up all the time...
It made sense, except that on our bikes, the running light voltage never drops out while you turn on the blinker. It's 12VDC constantly. The blinker wires alternate 12V while active.
Anyone know how to wire them up so the running light functionality works along with blinkers?
I dont want to waste 25 bucks on a 'blinker genie' when all they have in there are some diodes, just like the guide shows. I'm stumped.