Blackfin
New member
Just received and installed a Yoshi tail-tidy/fender eliminator on my 11 Fazer8. During installation I noticed that the two brackets that hold the turn signals and which double as the lower mounting points for the plate have zero hope of actually lining up with the holes in our Ontario plates.
I suppose this is "normal" but it also means that the turn signal brackets are retained by the top bolt only, with nothing but friction and bolt tightness holding the bracket in place.
This doesn't seem normal. Am I missing something?
I suppose this is "normal" but it also means that the turn signal brackets are retained by the top bolt only, with nothing but friction and bolt tightness holding the bracket in place.
This doesn't seem normal. Am I missing something?